Instructions
- Hits: 20463
The EpoxyMaster Epoxy Floor Coating Kit is an easy 6 step process.
Installation Instructions:
Step 1. Surface Prep
Sweep and shopvac the floor to remove all dirt, dust, and debris, ensuring a clean surface.
Step 2. Oil Stains
Be sure to remove oil stains and contaminants using a degreaser.
NOTE: Please review the included instructional guide and DVD prior to installation.

Step 3. Profile Surface
Use EpoxyMaster® 1 part Prep Solution to 4 parts water to clean and etch the floor surface before coating. Rinse thoroughly and allow the floor to dry completely.
Step 4. Mixing
Pre-mix Part A and then pour Part B into the 5-gallon bucket (Ratio: 2 parts A to 1 part B). Begin mixing for exactly 2 minutes using a drill motor and the included mixing wand. Pour the mixed epoxy completely out of the mixing pail within 60 seconds onto the floor.
Step 5. Application
Trim all the edges using the 3-inch trim brush. Squeegee and back roll 3 to 5 foot sections until the surface area is complete.
Step 6. Decorative Fleck
Place approximately a quarter size amount of EpoxyMaster® decorative fleck into the palm of your hand and throw underhand with an upward motion into the air. Add the optional non-slip aluminum oxide to the floor if desired.

It's as easy as 1... 2... 3...
The EpoxyMaster Instructional DVD
Please view our very detailed Instructional DVD below for the entire application process.
EpoxyMaster Instructional DVD in English from EpoxyMaster Films on Vimeo.
The filming of instructional methods on how to properly apply EpoxyMaster epoxy floor coatings.
EpoxyMaster DVD con instrucciones en Español from EpoxyMaster Films on Vimeo.
El rodaje de los métodos de instrucción sobre cómo aplicar correctamente recubrimientos para pisos epoxi EpoxyMaster.
DVD d’instructions d’EpoxyMaster en Français from EpoxyMaster Films on Vimeo.
Vidéo éducative d’instructions: Comment appliquer soi-même la couverture de plancher en époxy.